GE MAI10 369B184G5001

Technical Parameters

Channels: 8 isolated analog inputs for the GE MAI10 369B184G5001

Input Ranges (selectable per channel):

4–20 mA current loop (passive loop-powered)

0–10 V DC voltage input

Resolution: 16-bit ΔΣ ADC per channel

Accuracy: ± 0.1 % of full scale

Sampling Rate: 200 samples/sec per channel, simultaneous acquisition

Isolation: ≥ 1 kV channel-to-channel and channel-to-ground

Input Protection: Overvoltage clamp to ± 35 V; reverse-polarity protection

Filtering: Programmable digital low-pass filter (up to 50 Hz)

Connectors:

Backplane: dual 50-pin edge connectors to I/O-pack carrier

Field-wiring: right-angle header for 16-position pluggable terminal block on the GE MAI10 369B184G5001

Environmental Ratings:

Operating Temperature: –30 °C to +65 °C

Storage Temperature: –40 °C to +85 °C

Humidity: up to 95 % RH, non-condensing

Product function

Conditions, linearizes, and digitizes analog process signals through the GE MAI10 369B184G5001, forwarding calibrated data packets over the IONet Ethernet bus to the Mark VIe CPU. Built-in diagnostics detect open-loop, short-circuit, and out-of-range conditions, reporting faults to the control system for timely alarming and preventive action.

Core supporting modules

I/O-Pack Carrier: IS42xPSCAH1B power/carrier assembly providing backplane power and Ethernet connectivity to the GE MAI10 369B184G5001

Controller Module: IS200TPROH1C Mark VIe CPU handling data aggregation, scaling, and control algorithms

Complementary I/O Boards:

Digital-input modules (IS200TICIH2A)

Relay-output modules (IS400TRLYS1B)

Safety-I/O modules (IS220YSILS1B)

Extension components

Pluggable Terminal Blocks: 16-way screw-clamp blocks keyed to prevent mis-insertion

DIN-Rail & Panel-Mount Kits: Adapter clips and brackets for 35 mm rail or cabinet-panel installation

Shielding Accessories: Cable-shield clamps and ferrite beads for EMI suppression on analog loops

Calibration Fixtures: External loop calibrators for zero/span verification

Software support

Configuration & Calibration:

Channel-type selection, range, and filter settings defined via GE ControlST™/ToolboxST™ templates

Diagnostics & Monitoring:

Real-time loop-health, open-circuit, and short-circuit alarms available in HMI and OPC-DA tags

Self-test on power-up with diagnostic flags recorded in controller diagnostics

Firmware Updates: Delivered as part of Mark VIe system releases; applied through ToolboxST™

Documentation: Detailed in GE Mark VIe/VIeS I/O Installation Guide and the Analog Input Module Reference Manual for GE MAI10 369B184G5001.